The Hidden Forest

Hello guys,

I am using the MQ2 Very Vanilla package from Redguides which has as inbuilt plugin MQ2NAV. The plugin loads normally (and can be unloaded and reloaded normally) but /nav target does not work.

Whatever target (PC or NPC) and in all zones I tried, I get :

[Nav] Invalid nav destination:

Does someone has the same issue ?

Thanks in advance if someone has some input here.

The one from mqemulator seems to work ok.

Make sure you downloaded your navigation meshes, mq2nav won't work if it can't find the meshes. In VV, we're you start EQBC, you'll see a buttom to run the mesh updater.

Synwulfe wrote:Make sure you downloaded your navigation meshes, mq2nav won't work if it can't find the meshes. In VV, we're you start EQBC, you'll see a buttom to run the mesh updater.

Yes, thank you, I did this. And I get the regular "zone mesh loaded" message when I zone into a new zone. I cannot understand what is not working right.

PROBLEM SOLVED !

It is a blonde issue : I thought /nav target means typing "/nav %t" whereas 'target' is part of the command. "/nav target %T" works perfectly fine, apologies...