Lost my Macroquest Command window...

[eqwerty]

While recently configuring my UI (standard UI) I somehow managed to either close or move my macroquest command window off the screen. Can anyone tell me what I can edit in my UI file to move it back? It shows up where I would expect it to be in my character select screen, but disappears once I load up my toons. Thanks.

[Zolzimar]

Maybe it is just a resolution difference. Im still trying to figure out how to get mq2 going on titanium, shrug.

[Stickybuds]

This happened to me on one of my toons. After a bit of searching I found this answer

inside your MQ2 folder there will be a file called MQ2ChatWnd.ini

I just copied the settings for a character that had the window showing over the settings of the one that had it missing.

Below are the settings I used, it will make it a small window in the top left corner. Once its showing again you can move and size it how you wish. Hope this helps!

Code: Select all

ChatTop=30
ChatBottom=142
ChatLeft=1
ChatRight=286
Locked=0
Fades=1
Delay=0
Duration=500
Alpha=255
FadeToAlpha=255
BGType=1
BGTint.red=255
BGTint.green=255
BGTint.blue=255
FontSize=4
WindowTitle=MQ

Regards,
Sticky