Problem with MQ2NAV (MQ2 VV RG)

[Adonhiram]

Hello guys,

I am using the MQ2 Very Vanilla package from Redguides which has as inbuilt plugin MQ2NAV. The plugin loads normally (and can be unloaded and reloaded normally) but /nav target does not work.

Whatever target (PC or NPC) and in all zones I tried, I get :

[Nav] Invalid nav destination:

Does someone has the same issue ?

Thanks in advance if someone has some input here.

[Muergan]

The one from mqemulator seems to work ok.

[Synwulfe]

Make sure you downloaded your navigation meshes, mq2nav won't work if it can't find the meshes. In VV, we're you start EQBC, you'll see a buttom to run the mesh updater.

[Adonhiram]

Make sure you downloaded your navigation meshes, mq2nav won't work if it can't find the meshes. In VV, we're you start EQBC, you'll see a buttom to run the mesh updater.

Yes, thank you, I did this. And I get the regular "zone mesh loaded" message when I zone into a new zone. I cannot understand what is not working right.

[Adonhiram]

PROBLEM SOLVED !

It is a blonde issue : I thought /nav target means typing "/nav %t" whereas 'target' is part of the command. "/nav target %T" works perfectly fine, apologies...